Force Answer Mode - Multitech MT5634HD16 User Manual

MT5634HD8/16 User Guide
+++AT<CR> In-Band Escape Sequence
If the modem is online with a remote modem, you can cause the modem to enter command mode without
disconnecting the call by typing an escape code. The default escape code used by the modem is three plus
signs ( +++) followed by the letters AT , up to 10 command characters (most typically H , to hang up), and
E
NTER
command mode. For example, to hang up the modem at the end of a call, type +++ATH <CR>.
A

Force Answer Mode

You can use the A command to force the modem into answer mode. Type ATA when in command mode
to immediately bring your modem off-hook, out of command mode, into online answer mode, and to
cause it to transmit its carrier signal over the phone line. If no responding carrier tone is received by your
modem within forty-five seconds (or by the time you have specified in register S7), your modem stops
transmitting its tone, hangs up, and goes back into command mode.
On Go Back Online
n = 0, 1, or 3
Default: none
You can use the O command to bring the modem out of command mode and back into online mode. The
O command reverses the result of entering the escape code. The O command brings the modem into
whichever online mode (originate or answer) that it was in prior to entering command mode.
O0 causes the modem to exit command mode and return to online data mode.
O1 causes the modem to issue a retrain before returning to online data mode.
O3 causes the modem to issue a rate renegotiation before returning to online data mode.
30
. The modem then escapes to command mode, executes the command (if any), and remains in
CommPlete Communications Server