Multitech MT5634HD16 User Manual page 42

MT5634HD8/16 User Guide
S8 determines the length of the pause caused by a comma character in a dialing command. The default
setting is two seconds for the North American model, and four seconds for the International and U.K.
models. S8 may be set for up to 65 seconds. S8 also defines the length of time the modem waits before
retrying a call after it detects a busy signal. Some computer systems need more than two seconds to reset,
in which case you should increase the value of S8.
S10 Carrier Loss Disconnect Delay Time
Unit: 100 ms
Range: 1–254
Default: 20
S10 defines the length of time, in milliseconds, that the modem waits after a loss of carrier signal before
the it disconnects. The default setting is 2000 ms (20 units of 100 ms each). Maximum delay is 25400
milliseconds, or 25.4 seconds (decimal 254).
S11 Tone Dialing Spacing and Duration
Unit: 1 ms
Range: 50 - 150 (USA) or 80–255 (Canada, U.K., International)
Default: 95 (USA) or 80 (Canada, U.K., International)
S11 sets the speed of tone dialing (spacing and tone duration times). The default value is 95 units for
domestic models and 80 units for Canadian and International models, where each unit is one ms. In other
words, for domestic modems, each tone is sustained for 95 ms followed by a 95 ms pause. The minimum
S11 value allowed is 50 ms (50 units). The maximum S11 value is 150 ms (150 units).
S28 Enable / Disable V.34 Modulation
Unit: decimal
Range: 0, 1–255
Default:1 (enabled)
S28 enables or disables V.34 modulation. Setting S28 to zero (0) disables V.34 modulation. Any other
setting (1-255) enables V.34 modulation.
36 CommPlete Communications Server