Examples Of Reading Values; At Commands That Affect S-Registers - Multitech MT5634HD16 User Manual

Examples of Reading Values

1. To verify that you entered the value correctly in the preceding examples, type ATS8? and press
2. When configuring S-registers, it is a good practice to include the verification read command in the

AT Commands that Affect S-Registers

For maximum throughput, the MT5634HD8/16's default configuration is for originating a call to another
33,600 bps modem that supports error correction, data compression, and flow control. If the receiving
modem is not compatible, the MT5634HD8/16 can match any ITU-T or Bell standard modem (but not
proprietary protocols).
If you require a different configuration for your application, for example, if you want to use an
MT5634HD8/16 modem strictly as an auto answering device, or for service that does not support error
correction, you can selectively change the command parameters and S-register values in active memory and
save the new values by using the &W command.
The &W0 (or &W) command stores all current AT command and S-register values into nonvolatile
random access memory (NVRAM) and configures the modem so that it reads your custom settings in
NVRAM when the modem is turned on or when it is reset with the Z command. (The &F reset command
will continue to read the factory default settings in read-only memory [ROM].) For convenience, you can
include the &W command in the same command string that sets the new values in active memory, as in
the following example:
CommPlete Communications Server
E in the first example, ATS0? in the second example, and ATS2? in the third example. You
NTER
should receive the responses 005 , 004 , and 075 , respectively.
same command string as the configuration assignment command. In the three preceding examples,
type ATS8=5S8?, ATS0=4S3?, and ATS7=75S7?, respectively.
AT\N2&C1S0=10&W0<CR>
4 S-Registers
39