Dialing Commands - Multitech MT5634HD16 User Manual

Topic
Immediate Action
Flow Control
Escape
Sequences
Diagnostics
Speaker Settings

Dialing Commands

Dialing commands are used to dial and hang up.
Ds Dial
s = phone number
Default: none
The letter D in a command causes the modem to dial the telephone number immediately following it. For
example, if you type ATD5551212<CR> , the modem dials the number 555-1212.
The MT5634HD8/16 supports several dialing methods. With the D command, you can specify either pulse
(ATDP) or tone (ATDT) dialing. You can also modify the dialing command with several other characters
that are explained in the section "Dial Modifier Commands", later in this chapter.
The modem also lets you select either smart (wait-for-dial-tone) dialing or blind dialing. With smart
dialing, the modem waits for and detects dial tones and busy signals. With blind dialing, the modem works
with timed pauses (determined by the value of register S6), not dial tone and busy signal detection. See the
X command for more information on blind and smart dialing.
CommPlete Communications Server
Command Description
A/ Repeat last command
I Information request
&B V.32 auto retrain
&V View current configuration
&M0 Asynchronous mode
&K0 or \Q0 Flow control disabled
&K3 or \Q3 Hardware flow control
&K4 or \Q1 XON/XOFF flow control
\X0 XON/XOFF no pass-through
&J Auxiliary relay control
\J Enable data buffer control
\G Modem port flow control
\K Set break control
+ES=6 Enable synchronous buffered mode
+++AT<CR> Default in-band escape sequence
A Force answer mode
O Go back online
&T Self-test commands
L Monitor speaker volume
M Monitor speaker mode
3 AT Commands
Page
27
27
29
31
31
15