Table of Contents
Advertisement
Remove the control horns from the
control surfaces. Apply epoxy to the slot
in the aileron and lap. Make sure the
epoxy gets into the slot for a good bond
between the surfaces and control horn.
5.
Epoxy
Apply epoxy to the area of the control
horns that ist into the slots. Use enough
epoxy so the control horns will be fully
bonded to the ied surfaces.
6.
Before the epoxy fully cures, remove
the tape from around the control horn.
his will allow the epoxy to low around
the control horn, creating a small ilet
between the control horn and surface for
a iished look and secure bond.
Epoxy
7.
INSTALLING THE AILERON SERVOS
1.
Mininum servo spec.
Torque : 110 oz-in (7.9 kg-cm) @ 4.8V;
131 oz-in (9.4 kg-cm) @ 6.0V
Because the size of servos difer, you
may need to adjust the size of the precut
opening in the mount. he notch in the
sides of the mount allow the servo lead to
pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
7
Advertisement
Table of Contents
