Table of Contents
Advertisement
7.
Route the servo lead for the lap servo
out at the root of the wing. Connect the
lap servo to the radio system. With the
radio system on, place the lap servo into
position.
8.
Adjust the linkage so the lap is in the
mid-lap position. It may take a few tries
to properly adjust the linkage.
9.
Once adjusted, make sure all clevis re-
tainers are in position. Apply a drop of
threadlock near the clevis, then tighten
the nut against the clevis to keep the link-
age from changing length inside the wing.
10.
M3x10mm
11.
Set the lap control at the transmitter
to the down lap position. Adjust the lap
travel at the transmitter until it matches
the control throws listed in this manual.
12.
11
Advertisement
Table of Contents
