Table of Contents
Advertisement
6.
Fill Epoxy
When cutting through the covering
to remove it, cut with only enough pressure
to only cut through the covering itself. Cut-
ting into the balsa structure may weaken
it.
Using a modeling knife, carefully remove
the covering that overlaps the stabilizer
mounting platform sides in the fuselage.
Remove the covering from both the top
and the bottom of the platform sides.
7.
When you are sure that everything is
aligned correctly, mix up a generous
amount of 30 Minute Epoxy. Apply a thin
layer to the top and bottom of the stabi-
lizer mounting area and to the stabilizer
mounting platform sides in the fuselage.
Slide the stabilizer in place and realign.
Double check all of your measurements
once more before the epoxy cures. Hold
the stabilizer in place with T-pins or mask-
ing tape and remove any excess epoxy us-
ing a paper towel and rubbing alcohol.
Fill epoxy
8.
INSTALLING VERITICAL FIN
Required Parts
• Fuselage assembly
• Tail Set(Rudder and Elevator)
Required Tools and Adhesives
• Ruler,Pen,Knife
• 30-mminute epoxy
1.
Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the
fuselage.
2.
Remove covering
Fill Epoxy
37
Advertisement
Table of Contents
