Add A Wireless Camera - Motorola HMEZ2000 User Manual

Add a Wireless Camera

1. Bring the wireless camera into the same room where the Motorola controller is connected to your computer.
2. Remove the compartment cover from the bottom of the camera, and insert the 12-volt connector from the AC power adapter into the camera's power
socket. Be sure to push the connector all the way - you will hear a click when it is properly seated. Uncoil the power adapter cable, and plug the power
adapter into an AC power outlet. The light at the rear of the camera housing will be illuminated red.
3. Make sure that the controller is plugged in to your computer's USB port, power is connected to the controller, and your Motorola homesight Software
system is running.
4. Click on the SYSTEM SETTINGS button and then the Device Discovery entry to display the Discovery screen.
5. Click on the START DISCOVERY button. Check for the discovery is in progress message at the top of the device list.
6. The Motorola homesight Software system will begin listening for device registration messages from the wireless devices (such as cameras) that you wish
to add to your system.
7. Refer to the diagram below to locate the wireless camera's discovery button.
8. Use the tip of the 'discovery tool' included with the camera to momentarily press and then release the discovery switch (do this once only). A light on the
camera will turn green, to indicate that the controller has registered the camera.
9. After a few moments, an entry for the camera should appear in the device list, including a device image icon and a default device name.
10. Make a note of the name that is given to the camera (in case you wish to rename the camera later).
11. If the camera entry does not appear in the list within one minute, repeat steps 8 and 9.
12. Repeat steps 7 through 11 for each additional camera that you wish to add to your system.
13. Click on the STOP DISCOVERY button. Check for the discovery stopped message at the top of the device list.
14. Click on the DEVICE OVERVIEW button to display the Device Overview screen.
15. Select the name of the camera that you just installed from the camera selector drop-down list (located below the live camera view).
16. Make sure that you can see the image from the camera in the live camera view.
17. If necessary, click on the camera's CONFIG icon, and change brightness, contrast, camera name, or other camera properties, then click on the OK button.
18. Adjust the camera head position as necessary for the best live camera view.
15 Motorola homesight™ USER GUIDE