The power controller can be turned off by clicking on the associated lightbulb icon located in the Device Overview page. The lightbulb indicates what the current

status is of the controller. By clicking the icon, the status will change. The power controller can also be toggled on/off by pressing the button on the top of the

power controller. When the button is illuminated blue, the power controller is on.

Using the Power Controller in Macros

The power controller can be configured to turn on/off at set times or when certain events occur. For example, you can define a macro in the Event Scheduling

setup to turn the lights on everyday at 6:00 am. Likewise, you can configure a macro to turn the lights off when the Away button is pressed on the access panel.

Consult the Macros section of the help guide for more information.

Power Controller Properties

The power controller properties (Config) screen gives you control over device settings such as:

• device name

• power recovery state

• turn off after x minutes

To display the power controller properties screen, click on the Config icon (located at the right of each device entry in the Device Overview device list).

You can use the power controller properties screen to change one or more settings for a specific device, or revert to default settings. Changed device settings will

take effect after you click the OK button. To close the power controller properties screen without making changes, click on the CANCEL button. To return all

settings to default values, click on the DEFAULT button.

Motorola homesight™ USER GUIDE

Table of Contents