Pylontech Force-H2-V2 Manual page 8

Danger: Batteries deliver electric power, resulting in burns or a fire hazard when they
are short circuited, or wrongly installed.
Danger: Lethal voltages are present in the battery terminals and cables. Severe
injuries or death may occur if touch the cables and terminals.
Warning: DO NOT open or deform the battery module, otherwise the product will be
out of warranty scope
Warning: Whenever working on the battery, wear suitable personal protective
equipment (PPE) such as rubber gloves, rubber boots and goggles.
Warning:Force-H2-V2 system working temperature range: 0 ℃ ～ 50 ℃ ; Optimum
temperature: 18℃～28℃. Out of the working temperature range may cause
the battery system over / low temperature alarm or protection which further
lead to the cycle life reduction as well as. It will affect the warranty terms as
well.
Warning: For battery installation, the installer shall refer to NFPA70 or similar local
installation standard for operation.
Caution: Improper settings or maintenance can permanently damage the battery.
Caution: Incorrect inverter parameters will lead to a further faulty/damage to battery.
Reminding
1) It is very important and necessary to read the user manual carefully (in the
accessories) before installing or using battery. Failure to do so or to follow any of the
instructions or warnings in this document can result in electrical shock, serious injury,
or death, or can damage battery, potentially rendering it inoperable.
2) If the battery is stored for long time, it is required to charge them every six months,
and the SOC should be no less than 90%;
3) Battery needs to be recharged within 12 hours, after fully discharged;
4) Do not expose cable outside;
4