Led Indicators; Ana5 Board (Satcore Direct & Modem); Demod 4G Board (Satcore Direct, Rx / Rx-Light); Cpu Board - Safran SATCORE Series User Manual

SATCORE SERIES
USER's MANUAL
4.2.2

LED Indicators

4.2.2.1 Ana5 board (Satcore Direct & Modem)
The Ana5 board is the newest analog board constituting the Main Signal Processing board. It covers all
capabilities of Analog uplink board, Analog downlink board and Video board.
One LED is located at the front panel of the board.
Green LED. Turns to green and flashes at 1 PPS to show that the processing of the interface
D1
between the Main Signal Processing board and the chassis is correctly downloaded and
running.
Unlit (or high rate flashing) in case of Main Signal Processing board or CPU board failure or
in case of problem on the PCI bus
Six LEDs are located on this printed circuit board (open the top cover to check them).
Red LED. Illuminates to indicate that the local FPGA Digital Clock Manager is unlocked
D2
(shall not be illuminated in regular operations).
D3 Orange LED. Blinking at 1 Hz to show that the 250 MHz reference clock is present in the
local FPGA (shall blink at 1 Hz in regular operations).
D4 Green LED. IT indicator. Partially lit. Not significant.
Red LED. Illuminates to indicate that there is an error on the DMA transfer on PCIe (shall not
D5
be illuminated in regular operations).
Orange LED. Microblaze load indicator. Partially lit. Not significant.
D6
Blue LED. Illuminates to indicate that the local FPGA has been correctly downloaded at boot
D7
up (DONE signal, shall be illuminated in regular operations).

4.2.2.2 Demod 4G Board (Satcore Direct, RX / RX-light)

One LED indicator is located on the front panel of the board :
HW Turns to green and flashes at 1 PPS to show that the hardware is correct.
Unlit (or high rate flashing) in the case of Demodulator board or CPU board failure.

4.2.2.3 CPU Board

Refer to [RD4].
ZODIAC DATA SYSTEMS PROPRIETARY
D102751
ZDS Ref : Issue : 1 Rev.: 0
Date : July 11, 2019
Page 83