Sinclair S therm Series Service Manual page 97

No Full Name
1 Status of the compressor
2 Status of the fan
3 Status of the unit
4 Status of the water pump
5 Status of the water tank heater
6 Status of the 3-way valve 1
7 Status of the 3-way valve 2
Status of the compressor crankcase
8
heater
9 Status of the heater 1 for the main unit
10 Status of the heater 2 for the main unit
11 Status of the Chassis heater
12 Status of the heat exchanger heater
13 Status for the system defrosting
14 Status of the system oil return
15 Status of the thermostat
16 Status of other thermal source
17 Status of the 2-way valve
18 Status of antifreeze
19 Status of the door guard
20 Status of the 4-way valve
21 Status of disinfection
22 Status of the flow switch
3.2.5.2 Parameter Viewing
[Operation Instructions]
1.At the "VIEW" page, by touching "Parameter", it is able to view each parameter of the unit, as shown in the
figure below.
State Parameters
Displayed Name
Compressor
Fan
Unit status Cool/Heat/Hot water/Off
HP-pump
Tank heater
3-way valve 1
3-way valve 2
Crankc. heater
HP-heater 1
HP-heater 2
Chassis heater
Plate heater
Defrost
Oil return
Thermostat
Other thermal
2-way valve
HP-Antifree
Gate-Ctrl. Card in/Card out
4-way valve
Disinfection Off/Running/Done/Fail
Flow switch
Parameter View Page
93
Status
On/Off
On/Off
"Cool" is unavailable to
the heating only unit.
On/Off
On/Off "NA" for mini chillers
NA
On/Off "NA" for mini chillers
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
"Cool" is unavailable to
Off/Cool/Heat
the heating only unit.
On/Off
On/Off
On/Off
On/Off
On/Off
Remarks
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/