Sinclair S therm Series Service Manual page 79

●Temperature setting relative to the cooling mode is unallowed to the heating only unit.
●It will be memorized upon power failure.
●When the set point of "Upper WT-Heat"/ "Upper WT-Cool" is lower than that of the "Lower WT-Heat"/ "Lower
WT-Cool", or "Lower WT-Heat"/ "Lower WT-Cool" is higher than "Upper WT-Heat"/ "Upper WT-Cool", a window
will pop up, saying "Enter wrong!", and then resetting is required.
3.2.2.7 Weekly Timer
[Operation Instructions]
1.At the function setting page, by touching "Weekly timer", it will go to the setting page as shown below.
2.At the "Weekly timer" setting page, as shown in the figure below, the weekly timer can be set to "On" or "Off".
3.At the "Weekly timer" setting page, by touching the desired day (Monday~Sunday) it will access to the setting
page of this option.
4.At the weekday setting page, it is able to set the timer to "Valid" or "Invalid". Also, it is able to set three timing
periods, each of which can be set to "Valid" or "Invalid".
5.Then, by touching the "Save" icon, this setting will be saved.
[Notes]
●Three periods can be set for each day. The start time should be earlier than the end time for each period,
otherwise this setting will be invalid. In the same way, the latter should be earlier than the former.
●When the weekly timer has been activated, the display panel will act based on the current mode and
temperature setting.
●Timer setting for the weekday
"Valid" it indicates this setting works only when "Weekly timer" has been activated, unaffected by the holiday
mode.
"Invalid" indicates this setting does not work even though the "Weekly timer" has been activated.
●When both "Weekly timer" and "Holiday release" have been activated, setting of "Weekly timer" is invalid.
Only when "Holiday release" has been deactivated, setting of "Weekly timer" works.
●The priority sequence for timer setting from high to low is "Temperature timer", "Clock timer", "Preset mode"
and "Weekly timer". Setting with lower priority sequence is allowed but does not work when setting with higher
priority has been activated. However, it will work when the setting with higher priority has been deactivated.
●It will be memorized upon power failure.
3.2.2.8 Holiday Release
[Operation Instructions]
At the function setting page, by touching "Holiday release", it will go to the corresponding setting page, where it
can be set to "On" or "Off".
[Notes]
●When this function has been activated, at the 'Weekly timer" setting page, some week day can be set to
"Holiday release". In this case, the setting of the "Weekly timer" at this day is invalid unless it has been manually
set to "Valid".
●It will be memorized upon power failure.
75