Sinclair S therm Series Service Manual page 96

pressing "Cancel", this setting will not be saved and quit.
Display
No Full Name
1 T-HP max T-HP max
Cool run Cool run
2
time
Heat run Heat run
3
time
[Notes]
●For parameters with different defaults at different conditions, once the current condition changes, the
corresponding default also will change.
●All parameters at this page will be memorized upon power failure.
3.2.5 Viewing
[Operation Instructions]
1.At the menu page, by touching "VIEW", the control panel will go to the sub-menu page as shown in the figure
below.
3.2.5.1 Status Viewing
[Operation Instructions]
1.At the "VIEW" page, by touching "Status", it is able to view status of the unit, as shown in the figure below.
Range
Name
40~55℃
1~10min
time
1~10min
time
Default
104~131°F 50℃ /122°F
3min
[2-way valve Off]
5min
[2-way valve On]
3min
[2-way valve Off]
5min
[2-way valve On]
VIEW Page
Status View Page
92
Remark
It is unavailable to mini chillers.
When "Cool run time" has
expired and temperature
difference keeps at the standby
zone, the unit will stop.It is
unavailable to mini chillers.
When "Heat run time" has
expired and temperature
difference keeps at the standby
zone, the unit will stop.