Sinclair S therm Series Service Manual page 84

[Notes]
●When "Preset mode" has been set to "Hot water" and "Water tank" is to set to "Without", the preset "Hot
water" mode will be automatically switched to "Heat".
●When "Weekly timer" and "Preset mode" both have been set, priority will be given to the latter.
●When the water tank is available, the preset mode can be "Heat", "Cool", or "Hot water"; however, when the
water tank is unavailable, the preset mode can only be "Heat" or "Cool".
●"Start timer" should be earlier than "End timer", otherwise a dialog will pop up, saying "time setting wrong".
●The setting for "Preset mode" will works until it has been canceled manually.
●When "Start timer" is reached, the unit will perform the preset mode. In this case, mode and temperature
setting are still allowed but will not be saved to the preset mode. When "End timer" is reached, the unit will perform
OFF operation.
●This function will be memorized upon power failure.
●When "Weather depend" has been activated and the mode for "Preset mode" is set to "Hot water", "Weather
depend" will be deactivated when the setting mode has been switched.
3.2.2.15 Error Reset
[Operation Instructions]
At the function setting page, by touching "Error reset", a choice box will pop up, where by touching "OK" the
error will be reset and by touching "Cancel" the error will not be reset.
[Notes]
●It can be performed only when the unit is turned off.
3.2.2.16 WiFi Reset
[Operation Instructions]
At the function setting page, by touching "WiFi", a choice box will pop up, where by touching "OK" , the WiFi
setting will be reset, and by touching "Cancel" the choice box will quit and WiFi will not be reset.
3.2.2.17 Reset
[Operation Instructions]
At the function setting page, by touching "Reset", a choice box will pop up, where by touching "OK" all user
parameter settings will be reset and by touching "Cancel" it will back to the function setting page.
[Notes]
●This function is allowed only when the unit has turned off.
●This function is valid for "Temp. timer", "Clock timer", "Preset mode", "Weekly timer", and "Weather
depend".
3.2.3 User Parameter Setting
[Operation Instructions]
1.At the menu page, by touching "PARAMETER", it will back to the parameter setting page, as shown in the
figure below.
80