Sinclair S therm Series Service Manual page 89

[Notes]
●When "Water tank" is set to "Without", the "Air + hot water" mode is unavailable.
●When "Floor debug" and "Emergen.mode" have activated, function of the thermostat will be invalid.
●When "Thermostat" is set to "Air" or "Air + hot water", "
and the unit will run based on the mode set by the thermostat. Meanwhile, mode setting and On/Off operation by
the control panel will be ineffective.
●When "Thermostat" is set to "Air", the unit will run based on the setting of the thermostat.
●When "Thermostat" is set to "Air + hot water", when the thermostat is turned off, the unit can still perform the
"Hot water" mode. In this case, the ON/OFF icon at the homepage does not indicate the running status of the unit.
Running parameters are available at the parameter viewing pages.
●When "Thermostat" is set to "Air + hot water", operation priority can be set by the control panel (see Section
2.2.3 and 2.2.4 for more details.)
●The status of the thermostat can be changed only when the unit is turned off.
●When it has been activated, "Floor debug", "Air removal", and "Emergen.mode" are not allowed to be
activated.
●This setting will be memorized upon power failure.
3.2.4.6 Other Thermal
[Operation Instructions]
1.At the commissioning parameter setting page, by touching "Other thermal", the control panel will access to
the corresponding setting page.
2.At the "Other thermal" setting page, "Other thermal" can be set to "With" or "Without", "T-Other switch on"
can be set to the desired value. When "Other thermal" is set to "With", it is allowed to set the operating mode for
the backup thermal source.
[Notes]
●This setting will be memorized upon power failure.
●There are three working logics for it.
Logic 1
1.The set point of other thermal should be equal to that of "WOT-Heat" in "Heat" mode and "Heat + hot water"
Temp.timer
will be deactivated automatically
"
85