Table of Contents
Advertisement
IP Address Mode
IP Address
Subnet Mask
Gateway
DNS Address Type
DNS Server 1
DNS Server 2
Enable LLDP
Layer 2 QoS 802.1Q/VLAN Tag
Layer 2 QoS 802.1p Priority Value
Notes
If the GDS371x is behind SOHO (Small Office Home Office) router with port forwarding configured for remote access, static IP should be used to
avoid IP address changes after router reboot.
TCP port above 5000 is suggested to Port forward HTTP for remote access, due to some ISP would block port 80 for inbound traffic. For example,
change the default HTTP port from 80 to 8088, to make sure the TCP port will not be blocked.
In addition to HTTP port, RTSP port is also required to configure via port forwarding, so that the remote party can view the video stream.
If the default TCP port 80 is changed to port "A", then RTSP port should be "2000+A" (changed from default TCP 554). Both TCP port "A" and
"2000+A" should be configured for port forwarding in the router. For example, of the HTTP port is changed to 8088, the RTSP port should be
10088, both TCP ports 8088 and 10088 should be configured for port forwarding to have remote GDS3710 access: 8088 for web portal, and
10088 for video streaming.
OpenVPN® Settings
This page allows users to configure OpenVPN settings.
Selects DHCP or Static IP. Default DHCP. (Static recommended)
Configures the Static IP of the GDS3710.
Configures the Associated Subnet Mask.
Configures the Gateway IP address.
Specifies the DNS type used: Dynamic DNS or Static DNS.
Configures DNS Server 1 IP address.
Configures DNS Server 2 IP address.
Controls the LLDP (Link Layer Discovery Protocol) service. The default setting is "Enabled".
Assigns the VLAN Tag of the Layer 2 QoS packets.
Default value is 0.
Assigns the priority value of the Layer2 QoS packets.
Default value is 0.
Table 12: Network settings
Figure 78: OpenVPN Settings page
Advertisement
Table of Contents
