Krick 20320 Building Instructions page 35

104
5. Safety Bar
Bend from brass wire 1,5 x 170 mm the safety
bar (72) for the flybridge.
First bend the angles as shown on the top view
on the plan and at the end bend the outer ends
downwords as shown in the side view.
6. Hand Rail
Prepare the hand rail from brass wire 1,5 x 195
mm and 6 split pins (71). Mark the holes at the
sides of the superstructure and drill with 1,5
mm. Slide the split pins onto the wire and fix
the ends into the holes. To achieve an equal
distance to the wall, slide some rest pieces of
wood 3 mm between wall and rail.
65
71
Stand Februar 2016
7. Bow Rail
Bend the bow rails from brass wire 1,5 x 210
mm (73) place the rail support (74) with split
pin and glue into the centre of the rail. Use a
small rest of wire as pin into the deck.
72
8. Aft Rail
Work the same way with the back rail 74 und
75.
Seite 13
73 71
74
Rest
75 71
74
Rest
©
Krick Modelltechnik Knittlingen