Krick 20320 Building Instructions page 38

Apply some glue to the outer ring and into the
center of the wheel and place the spokes care-
fully that they are lying up to the center hole,
but leave it free.
Now place the second outer ring, that the
grooves are placed on the spokes.
Apply some glue to the upper center piece and
place it as well onto the first one.
Now press the complete steering wheel with
some weight until the glue has set.
Carefully cut out the laser cut dummy spokes
from the lower laser part. Then sand the
wooden parts carefully.
Cut a 10 mm brass piece as a shaft and fix it
with glue in the center hole of the steering
wheel. Also place the 2 distance rings with
wood glue.
Stand Februar 2016
Now you can stain and varnish the steering
wheel and fix it at the helmstand.
14. Other Fittings
At the end fit all other fittings to the model. For
this several pictures are shown as follows.
91
Seite 16
90
88
92
©
Krick Modelltechnik Knittlingen