Krick 20320 Building Instructions page 32

After the glue has set, you can fit and glue the
front walls (43 + 44). The front panels for the
side (44) have enough oversize for an easy fit.
Now prepare the false edges 47 und 48 from
rest pieces of plywood 3 mm and glue them in
place.
47
48
Now the body shell of the superstructure is
ready.
6. Alignment to Deck
At this stage the superstructure will be placed
on the deck and the curve of the lower edge
has to be aligned with the curve of the deck.
This has to be done mainly in the front area.
For this you can mark the deck line to the su-
perstructure with a pencil, layed flat onto the
deck. Then sand the curve.
7. Painting
Now the superstructure can be sprayed with
filler and sanded several times and afterwards
Stand Februar 2016
43
rest material 3 mm
Seite 10
you can use a lacquer for the finish in the
wished colour.
III. Details
In the following steps the accessories will be
made.
Door, radarbridge, seats, anchor winch, bow
reel, stairs, ladder, radar, throttle lever
1. Door
Sand and varnish the door (62) and glue it to
the painted back wall. Then bend the door
handle from brass wire 1,5x15 mm (108) and
slide a brass tube 2x1,5x7 mm (104) over it for
a thicker handle.
62
2. Radar Bridge
Take part 58 from the laser sheet.
Glue two brass tubes (63) 2x1,5x100 mm on to
the board just at the outer edges. Bend from
brass wire 1,5 mm four supports (66). Fit the
angle according to the angle of the side walls
of the flybridge.
66
63
58
63
66
©
Krick Modelltechnik Knittlingen
108
66
66