Krick 20320 Building Instructions page 34

61
64
68
Glue the first two distance tubes 5 mm from
the lower end of both vertical rods. Then place
alternately one Step and two distance tubes
onto the rods and fix the with a drop of super-
glue.
Drill the holes for the ladder at the correct
place into the cockpit floor. Then bend the
upper end of the longer rod at a distance of 30
mm from the highest step horizontally to the
side.
30 mm
Biegen Sie die Relingstütze aus Brass Wire
1,5 x 45 mm (69).
Stand Februar 2016
67
drill
Seite 12
Place hand rail (70) without glue and check the
height of the rail support.
70
Make the lower rail from two split pins (71) and
the tube (70).
71
Make the end piece at the left ladder rod from
a piece of brass tube 2 x 7 mm (104) and glue.
©
Krick Modelltechnik Knittlingen
69
30 mm
70