Krick 20320 Building Instructions page 37

12. Radar
Cut out the two halves (101) of the radar at the
vertical end. Then sand the edge on a flat
piece of abrasive paper, grade 600 down to
measure. Now glue the two halves together
and paint if wished. Place the sticker onto the
front.
101
13. Throttle Lever
Make the throttle lever from parts 102, 103 and
104. Bend the lever from brass wire 1,5 x 25
mm. Drill a hole of 1.5 mm into the base (102)
and round the upper edges. Glue handle (104)
on the lever. After painting the lever can be
glued into the base.
Stand Februar 2016
102
14. Assembly of the steering wheel
For this assembly fo the steering wheel you will
need the small laser sheet, 12 cm of brass wire
1 mm, and white glue or Aliphatic glue, a mod-
elling knife, a wire cutter and some sand pa-
per.
Use the cut out on the laser sheet to cut equal
lengths for 6 spokes fom the brass wire 1 mm.
Now cut ut the l5 laser parts from the sheet as
shown.
Seite 15 ©
Krick Modelltechnik Knittlingen