Command Bar Area - Teledyne T3AWG2152 Operator's Manual

Command Bar Area

The command bar contains several touch buttons to control the instrument. Below a detailed
description of this bar is provided.
Please note that the position of the buttons described below may change due to instrument different
model.
Command Bar Buttons Description
Running/Stopped Button – Use this button to set the instrument in Running
state (or Ready to receive a Trigger) or in the Stopped state. If the button is
green the instrument is running while if it is grey the instrument is stopped.
Bushing the button will change the instrument state.
Trigger Button – Use this button to send an internal software trigger to the
instrument. Independently from the setting this trigger is always received.
Output Channels Buttons – Press CH1, CH2, ... ,CHN to change the Output
channel page.
If you press again the selected Channel, you can turn OFF/ON. When a
channel is OFF, it is mechanically disconnected from the output.
Copy Ch1 (Ch2, ..., ChN) Button –This button copies all the channel settings
to the other channels. When you press the button a dialogue window
appears to Confirm or Cancel the operation. You can copy the channel 1 into
channel 2, ..., channel N or the channel 2 into channel 1, ..., channel N
depending on the current selecting one.
Settings Button – Use this button to open the output channel Settings and
device Settings. (For more information, please refer to the relative section).
Import Button – Use this button to open the page where you can import a
waveform from a file and use it as Carrier Waveform, Modulation Law or
Sweep Profile. (For more information, please refer to the relative section).
Details Button – Use this button to open a page that summarize all channel
settings.
Default – Use this button to restore the default value of all parameters of
the instrument.
Operator's Manual Simple AFG Application
28