Functions For Receive - Icom IC-78 Instruction Manual

n

Functions for receive

D
RIT function
The RIT (Receive Incremental Tuning) function com-
pensates for off-frequencies of communicating sta-
tions. The function shifts the receive frequency up to
1.2 kHz without moving the transmit frequency.
q Rotate the RIT control to cancel the off-frequen-
cies.
• "
" is displayed on the display.
• The transmit frequencies are not shifted.
D
Preamp
The preamp amplifies received signals in the front
end circuit to improve the S/N ratio and sensitivity.
Turn this function ON when receiving weak signals.
➥ Push [P.AMP] to turn the preamp ON or OFF.
• Preamp functions below 1.6 MHz, but sensitivity may
be reduced in some cases.
D
Attenuator
The attenuator prevents desired signals from distort-
ing when very strong signals are near the desired fre-
quency or when very strong electric fields, such as
from broadcasting stations, are near your location.
➥ Push [ATT] to turn the 20 dB attenuator function
ON or OFF.
• "ATT" is displayed when the attenuator is turned ON.
Noise blanker
D
The noise blanker reduces pulse-type noise such as
that generated by automobile ignition systems.
q Push the [NB] switch to turn the noise blanker ON.
• The [NB] icon is displayed.
w Hold down the [NB] switch for 1 second to enter
the noise blanker level setting condition.
e Rotate the Channel Selector to adjust the noise
blanker level.
r Push [NB] to exit the setting condition.
t Push [NB] again to turn the noise blanker func-
tion OFF.
• The [NB] icon disappears.
• When using the noise blanker, received signals
may be distorted if they are excessively strong.
• The noise blanker function in AM mode can be
deactivated depending on the Initial Set mode
setting. (p. 30)
w To cancel the RIT function,
rotate the RIT control to the
center position.
• "
" disappears.
Appears when the
preamp is ON.
Appears when the
attenuator is ON.
3
OPERATION
RIT off position
[NB] switch
Appears when the
noise blanker is ON.
18