Grandstream Networks GRP261 Series Administration Manual page 49

802.1X mode
802.1X Identity
MD5 Password
802.1X CA Certificate
HTTP Proxy
HTTPS Proxy
Bypass Proxy for
Layer 3 QoS for SIP
Layer 3 QoS for RTP
Release DHCP On Reboot
Enable DHCP VLAN
Enable Manual VLAN Configuration
Layer 2 QoS 802.1Q/VLAN Tag
Layer 2 QoS 802.1p Priority Value
PC Port Mode
PC Port VLAN Tag
Network �� Advanced Settings
Allows the user to enable/disable 802.1X mode on the phone. The default value is
disabled. To enable 802.1X mode, this field should be set to EAP-MD5, users may
also choose EAP-TLS, or EAP-PEAPv0/MSCHAPv2.
Enter the Identity information for the 802.1x mode.
Note: Letters, digits and special characters including @ and – are accepted.
Enter the MD5 Password for the 802.1X mode.
Note: Letters, digits and special characters including @ and – are accepted.
Uploads / deletes the 802.1X CA certificate to the phone; or delete existed 802.1X
CA certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy server
will act as an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy server
will act as an intermediary to route the packets to the destination.
Configures the destination IP address where no proxy server is needed. The phone
will not use a proxy server when sending packets to the specified destination IP
address.
Defines the Layer 3 QoS parameter for SIP. This value is used for IP Precedence,
Diff-Serv or MPLS.
The default value is 26.
Defines the Layer 3 QoS parameter for RTP. This value is used for IP Precedence,
Diff-Serv or MPLS.
The default value is 46.
Configures whether the phone will release the DHCP lease on reboot.
Enabled by Default.
Enables auto configure for VLAN settings through DHCP.
Disabled by default.
Enables/disables manual VLAN configuration. When this option is set to Disabled,
the phone will bypass VLAN configuration and only use the DHCP VLAN to configure
VLAN tag and priority.
Default is "Enabled".
Assigns the VLAN Tag of the Layer 2 QoS packets. The valid range is 0 – 4094.
The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The valid range is 0 – 7.
The default value is 0.
Configure the PC port mode. When set to "Mirrored", the traffic in the LAN port will
go through PC port as well and packets can be captured by connecting a PC to the
PC port.
The default setting is "Enabled".
Assigns the VLAN Tag of the PC port. The valid range is 0 – 4094.
The default value is 0.