Grandstream Networks GRP261 Series Administration Manual page 46

IM
Enable IM Popup
Instant Message Popup Timeout
Play Tone On Receiving IM
Call Features
Enable Active MPK Page
Enable Active VPK Page
Local Call Recording Feature
Default call log type
Saved Local Call Recording Location
Replace the oldest call record
Download Local Call Recordings
Settings �� Ringtone
Call Progresses Tones:
● System Ring Tone
● Dial Tone
● Second Dial Tone
● Message Waiting
● Ring Back Tone
● Call-Waiting Tone
● Busy Tone
● Reorder Tone
Call Waiting Tone Gain
Speaker Ring Volume
Notification Tone Volume
If set to "No", phone will not show a pop up when receiving an IM.
The default setting is "Yes".
Configures the number of seconds that the message will remain on screen. The
valid range is 10 – 900.
The default setting is "10".
If enabled, phone will play a short tone when receiving an IM during idle state.
The default setting is "Disabled".
When the option is enabled, Active MPK Page on the extension boards will be
disabled.
The default setting is "No".
Enables Active VPK Page to be displayed on LCD when there are active VPKs.
The default setting is "No".
Gives the ability to record calls locally while on the call screen.
The default setting is "Disabled".
Sets the default call log list after select MENU��CALL HISTORY.
Broadsoft Call Log or Local Call Log option will only show its own list. Default option
will keep both call log lists.
The default setting is "Default".
Configures location where the recordings will be stored.
When enabled, the oldest call record will be replaced with the newest one when the
storage is full. If the option is disabled, the call recording feature will stop recording
automatically.
Default is "Disabled".
When there are recordings presented, you may download them here.
Configures ring or tone frequencies based on parameters from local telecom. The
default value is North American standard. Frequencies should be configured with
known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms
and a pause of OFF ms and then repeat the pattern. Up to three cadences are
supported.
Configures the call waiting tone gain to adjust call waiting tone volume (Low,
Medium or High). The default setting is "Low".
Configures speaker ring volume.
The valid range is 0 to 7.
The default setting is 5.
Configures notification tone volume.