Table of Contents
Advertisement
UK
4.1 Lift Arms
The rest position of the lift arms may either be vertical or backwards and depends on the tractor
design. For vertical rest position the supplied lock fittings must be used and fitted when the lift is
lowered. The lift arms will be locked when the lift is lifted to top position.
In rest position backwards, the arms must be tipped manually up until they hit the limit stop, and no
locking fittings must be used.
4.2 Coupling of Tool
Fit the balls on the tool, drive the tractor into position and lift the Front-Lift so that the quick-
couplings catch the tool.
4.3 Uncoupling of Tool
We recommend that you place the tool on a plane ground. The locking mechanism is released when
the tool is hanging freely and then the Front-Lift is lowered.
When the tractor motor is started, no persons may stay within the
Warning !
reach of the tractor, Front-Lift or mounted Tool.
4.4 Lubrication
When lubricating the Front-Lift and any mounted tool, lower the Front-Lift, brake the tractor, stop
the motor and remove the ignition key!
There are 6 lubricating points on the Front-Lift, which must be lubricated after every 25 hours of
operation, and 2 lubricating points on the Front-Lift, which must be lubricated after every 8 hours of
operation, and after each cleaning in order to press any water out of the bearings.
F r o n t – L i f t 1 5 . 0 1
4. Operating Instructions
7
27-05-2013
Advertisement
Table of Contents
