Table of Contents
Advertisement
Vip-Roller NG 4,5 – 5,4 – 6, 3 – 7, 3 – 8,2m
UK
20-08-2019
4. Operating Instructions
Attachment
On delivery, the roller is in transport position. When the roller is attached, check that the towing
hook height is 400-500 mm. Reverse the tractor, put in and secure the draw bolt.
Raise the support leg and place it in the transport fittings on top of the drawbar. The roller requires
one double-acting and one single-acting hydraulic outlet.
Now connect the hydraulic hoses, in the hydraulic outlets of the tractor.
IMPORTANT: Check that the male end, mounted by the factory, fits the female end of the tractor.
Now pressurise the tip cylinder so that the side sections are tipped free of the transport fittings. Then
the side sections, are turned out by means of the wing cylinder.
Now the roller is hydraulically tipped into working position by means of the tip cylinder.
Transport
At changeover for transport, the roller is tipped totally backward by pressurising the tip cylinder.
Now pressurise the wing cylinder so that the side sections turn forward, towards the stop on the
transport fittings of the tail.
When both sides lie in parallel with the tail, they are lowered down into the transport fittings by
releasing the pressure of the tipping cylinder.
Now relieve the hydraulics totally, and the roller is ready for transport.
Rolling
Speed: max. 10 km/h.
When turning, drive in wide curves as far as possible. The turning should be performed no sharper,
than all roller rings are still rotating forward.
Only lower the wheels when making ready for transport position.
Do not drive over any large stones, which are not moveable.
7
Back to the table of contents
Advertisement
Table of Contents
