Table of Contents
Advertisement
UK
3.1 Generally
As standard the Front-Lift is supplied with a complete mounting kit consisting of bolts, nuts,
washers, hydraulic hoses, quick-couplings and cable binders/strips.
3.2 Mounting of Front-Lift
The following mounting instruction is a general instruction in the mounting of a HE-VA Front-Lift.
There may be deviations in special cases, and if in doubt, please contact HE-VA.
1.
Dismantle the basic weight of the tractor.
2.
Dismantle the lift in one side so that the side plates can pass the front block.
3.
Mount the first side plate and tighten slightly.
4.
Mount the second side plate and tighten slightly.
5.
Mount the top lever attachment, cylinders and lifting console.
6.
Now tighten all bolts. Remember it is very important that the bolts are lubricated in
order to achieve adequate tightening. See the table.
7.
Fit the hydraulic hoses to the hydraulic tractor PTO. The hoses must not hang loose
but must be attached e.g. by means of strong cable binders/strips. The hoses may not
touch any sharp edges, which may damage them. Pay special attention in connection
with the movements of the front end.
8.
With Front-Lifts with spring system the manometer with test hose must be fitted to a
place visible from the driver's seat (e.g. on the guard).
9.
It may be necessary to adjust the control swing after the mounting of the Front-Lift
depending on the tyre fitting and wheel distance.
NOTICE! No hydraulic hoses may be fitted in the driver's cab.
When connecting the hydraulics there must be accordance between the movements of the hydraulic
lever and the movement of the Front-Lift!
Metrical Thread
Grade 8.8
M12
81
M14
128
M16
197
M18
275
M20
385
M22
518
M24
665
F r o n t – L i f t 1 5 . 0 1
3. Assembly Instruction
Maximum Tightening Torques in Nm
Grade 10.9
114
181
277
386
541
728
935
5
27-05-2013
Grade 12.9
136
217
333
463
649
874
1120
Advertisement
Table of Contents
