Honda CB160 Shop Manual page 128

124
Fig. 6. 41
Drain plug
Fig.
6. 42 Oil gauge (dip stick!
Fig. 6. 43
Grease linings on lefl
fig. 6. 44
Greasa fittings on righl
6. INSPECTION AND MAINTENANCE
b. Prop the vehicle on a stand and run the engine
to warm it. Remove the drain plug and draill
the oil. (Refer to Fig. 6. 41)
c. Replace the drain plug and fill with oil.
d. After pouring l .5 liters (.39 US gal., .33 Imp
gaf.l, check level with dip stick attached .. to
filler cap. (Refer to Fig.
6. 42)
e. Name and weight of oil :
Honda Ultra Oil
above
below
below
(CAUTION)
15 deg.
C.
15 deg.
C.
0 deg.
C.
i
30
i2ow
i
lOW
( l ) Do not exceed the oil level indicated on the
gauge.
(2) Change periodically as the oil becomes dirty
after use.
(3) Oil of doubtful quality should not be used.
(4) Do not use oil which has been contaminated by
water or direct.
2. Parts not requiring periodical lubrication
Some parts do not require periodical lubrication,
but need be lubricated only when disassembled for
some reason.
Steering bearing cone race}
Throttle grease
3. Grease
a. Greasing
Use a grease pump to lubricate those sections
which are provided with grease fittings. When
greasing, allow surplus to appear around the fitting.
Fiber grease should be used. (Refer ta Figs. 6. 43
and 6. 44)