Table of Contents
Advertisement
4.
l
O REAR FORK AND REAR FENDER
3.
Measurement of rear fork pivot bolt
Standard value
I
Correction limit
Outside
13.925 ta 13.968 mm
diameter
1.557
11
ta .558
11
1
Bend
Below 0102
4.
Measurement of twist of the rear fork.
(Refer
to Fig.
4.
63)
Standard value
Correction limit
Twist
Below ±0.1
1.0039
11
)
(CAUTION)
Measurement should be made when the rear
fork pivot bushing and the center collar are inserted
into the rear fork.
5.
Inspect the rear fender and the drive chain case
for stains and dents.
6.
Inspection of elongation of the drive chain should
be made by the same method as for same method
as for cam chain inspection.
D.
Assembly
1.
Install the rear fender.
2.
Drive in the pivot bushing and the center collar.
Insert the rear fork seal cap.
3.
By
inserting
the pivot bolt through the side
bracket, couple the
rear
fork
and the frame.
Tighten by the l 4 mm lock nut.
4.
Install the rear cusion.
5.
Install the rear wheel.
6.
Install the drive chain.
7.
When the assembly is finished, adjust the rear
brake pedal and tension of the chain.
8.
Install the drive chain case. (Refer to Fig.
4.
64)
9.
Insert grease in the grease fitting.
( Refer ta
Fig.
4.
65)
,..;
Fig.
4.
62
Disassembly of rear fender
fig.
4.
63
Twist of rear fork
fig.
4.
64
Installation of chain cose
fig.
4.
65
Inserting grease
71
Hide quick links:
Advertisement
Table of Contents
