Table of Contents
Advertisement
VLT Micro Drive Selection
4.1.9 FC 51 IP21 Kit Mounting Instruction
Step 1
Fit top cover on frequency converter.
Step 2
Remove knockouts on metal plate and fit rubber
grommets.
VLT Micro Drive Design Guide
Step 3
Mount metal plate on frequency converter and tighten
screws. Tightening torque: 2Nm.
Step 4
Fit bottom cover on frequency converter and tighten
screw.
NOTE! IP21 is only achieved with LCP11 or LCP12
mounted.
®
MG02K102 - VLT
is a registered Danfoss trademark
4
4
33
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT Micro Drive PK18 and is the answer not in the manual?