Table of Contents
Advertisement
Programming
7 Programming
7.1 How to Programme
7.1.1 Programming with MCT-10 Set-up Software
The frequency converter can be programmed from a PC
via RS485 com-port by installing the MCT-10 Set-up
Software.
This software can either be ordered using code number
130B1000 or downloaded from the Danfoss Web site:
www.danfoss.com, Business Area: Motion Controls.
Please refer to manual MG10RXYY.
7.1.2 Programming with the LCP 11 or LCP
12
The LCP is divided into four functional groups:
1.
Numeric display.
2.
Menu key.
3.
Navigation keys.
4.
Operation keys and indicator lights (LEDs).
Illustration 7.1 LCP 12 with Potentiometer
VLT Micro Drive Design Guide
Illustration 7.2 LCP 11 without Potentiometer
The display:
Different information can be read from the display.
Set-up number shows the active set-up and the edit set-
up. If the same set-up acts as both active and edit set-up,
only that set-up number is shown (factory setting).
When active and edit set-up differ, both numbers are
shown in the display (Setup 12). The number flashing,
indicates the edit set-up.
Illustration 7.3 Indicating Set-up
The small digits to the left are the selected parameter
number.
Illustration 7.4 Indicating Selected Parameter No.
The large digits in the middle of the display show the
value of the selected parameter.
®
MG02K102 - VLT
is a registered Danfoss trademark
7
7
63
Advertisement
Table of Contents
