Table of Contents
Advertisement
VLT Micro Drive Selection
Step 3
Place bracket on back of the LCP, then slide down. Tighten
screws and connect cable to LCP.
NOTE! Use the provided thread cutting screws to fasten
connector to LCP. Tightening torque: 1.3Nm.
VLT Micro Drive Design Guide
Step 4
Connect cable to frequency converter.
NOTE! Use the provided thread cutting screws to fasten
connector to the frequency converter. Tightening torque:
1.3Nm.
®
MG02K102 - VLT
is a registered Danfoss trademark
4
4
29
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT Micro Drive PK18 and is the answer not in the manual?