Introduction - Siemens SIMATIC S7-300 Getting Started

Introduction

Introduction
This Getting Started contains a practical example guiding you through thirteen steps in
commissioning a fully functional application, and showing you how to carry out motion
commands. It is thus a valuable help in getting started with the basic functions of a
CPU 317T-2 DP.
Depending on your degree of experience, working through the sample will take between two
and three hours.
Note
This Getting Started presumes that you have connected a SINAMICS
the DP(DRIVE) interface of the CPU 317T-2 DP In case you do not have a drive, we
recommend you refer to the Getting Started Documentation "CPU 317T-2 DP: Controlling a
virtual axis".
Note
You can also use the CPU 315T-2 DP instead of the CPU 317T-2 DP. To do this, select
CPU 315T-2 DP in HW Config. Otherwise, the configuring steps are the same.
CPU 317T-2 DP: Controlling a SINAMICS S120
Getting Started, 03/2008, A5E00480391-03
1
S120 drive to
SINAMICS
5