Task - Siemens SIMATIC S7-300 Getting Started

2.2

Task

Example configuration
Task
Configuration of an axis using HW Config and S7T Config. You then operate this axis with
the help of a STEP 7 user program.
The task is divided into the following learning units:
Step
1
2
3
4
5
6
7
8
9
10
11
12
13
CPU 317T-2 DP: Controlling a SINAMICS S120
Getting Started, 03/2008, A5E00480391-03
Learning unit
Wiring
Configuring the CPU 317T-2 DP in HW Config
Changing the transmission rate at the MPI/DP interface
Vital settings in your DP(DRIVE) configuration
Generating technology system data
Configuring the drive with HW Config
Configuration of the PG/PC interface
Downloading the hardware configuration to the target hardware
Configuration of the SINAMICS drive with S7T Config
Step: Configuring the axes with S7T Config
Creating the technology DBs
Controlling the axis with the STEP 7 user program
Trial run
Preparation
2.2 Task
9