Table of Contents
Advertisement
Removing the power-adapter port
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
base
cover.
2. Remove the
wireless
card.
3. Remove the
memory
modules.
4. Remove the
solid-state
5. Remove the
rear-I/O
6. Remove the
computer
7. Remove the
coin-cell
8. Remove the
heat-sink
9. Remove the battery.
10. Remove the
system
board.
Procedure
1. Lift the power-adapter port bracket off the power-adapter port.
2. Lift the power-adapter port off the palm-rest assembly.
3. Remove the cable from the routing guides on the palm-rest assembly.
computer. After working inside your computer, follow the instructions in
drive.
cover.
base.
battery.
assembly.
After working inside your
41
Advertisement
Table of Contents
