Replacing the display panel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Slide the display cable into the connector on the display panel and close the latch to secure the cable.
2. Adhere the tape that secures the display cable to the display panel.
3. Turn the display panel over and gently place it on the display back-cover.
CAUTION: Ensure that no cables are under the display panel.
4. Align the screw holes on the display panel with the screw holes on the display back-cover and antenna assembly.
5. Replace the four screws (M1.6x2) that secure the display panel to the display back-cover and antenna assembly.
Post-requisites
1. Replace the camera.
2. Replace the
display
bezel.
3. Replace the
display
assembly.
4. Replace the
system
board.
5. Replace the battery.
6. Replace the
heat-sink
7. Replace the
coin-cell
8. Replace the
computer
9. Replace the
rear-I/O
10. Replace the
memory
modules.
11. Replace the
solid-state
12. Replace the
wireless
card.
13. Replace the
base
cover.
64
computer. After working inside your computer, follow the instructions in
assembly.
battery.
base.
cover.
drive.
After working inside your