Installing the keyboard-controller board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the keyboard-controller board and provides a visual representation of the
installation procedure.
Steps
1. Using the alignment posts, place the keyboard-controller board into the slot on the palm-rest and keyboard assembly.
2. Replace the screw (M2x2) that secures the keyboard-controller board to the palm-rest and keyboard assembly.
3. Connect the keyboard-controller board cable to the system board and close the latch.
4. Connect the keyboard-backlight cable to the keyboard-contoller board and close the latch.
5. Connect the keyboard cable to the keyboard-controller board and close the latch.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
rear
cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
59