Table of Contents
Advertisement
Replacing the display hinges
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Align the screw holes on the display hinges with the screw holes on the display back-cover and antenna assembly.
2. Replace the eight screws (M2.5x2.0L) that secure the display hinges to the display back-cover and antenna assembly.
3. Route the antenna cables through the routing guides on the display back-cover and antenna assembly.
4. Route the logo-board cable through the routing guides on the display back-cover and antenna assembly.
5. Route the display cable through the routing guides on the display back-cover and antenna assembly.
6. Place the hinge caps on the display hinges and press down to snap them into place.
Post-requisites
1. Replace the
display
panel.
2. Replace the
display
bezel.
3. Replace the
display
assembly.
4. Replace the
system
board.
5. Replace the battery.
6. Replace the
heat-sink
7. Replace the
coin-cell
8. Replace the
computer
9. Replace the
rear-I/O
10. Replace the
memory
modules.
11. Replace the
solid-state
12. Replace the
wireless
card.
13. Replace the
base
cover.
computer. After working inside your computer, follow the instructions in
assembly.
battery.
base.
cover.
drive.
After working inside your
67
Advertisement
Table of Contents
