Table of Contents
Advertisement
Replacing the display bezel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Place the display assembly on a clean and flat surface.
2. Connect the logo-board cable to the logo board.
3. Adhere the tape that secures the logo-board cable to the logo board.
4. Slide the alien head logo-board cable into the logo board and close the latch to secure the cable.
5. Carefully turn the display bezel over.
6. Align the display bezel with the display back-cover and antenna assembly and gently snap the display bezel into place.
Post-requisites
1. Replace the
display
assembly.
2. Replace the
system
board.
3. Replace the
heat-sink
4. Replace the battery.
5. Replace the
coin-cell
6. Replace the
computer
7. Replace the
rear-I/O
8. Replace the
memory
modules.
9. Replace the
solid-state
10. Replace the
wireless
card.
11. Replace the
base
cover.
56
computer. After working inside your computer, follow the instructions in
assembly.
battery.
base.
cover.
drive.
After working inside your
Advertisement
Table of Contents
