Table of Contents
Advertisement
Replacing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Route the cables through the routing holes on the palm-rest assembly.
2. Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
3. Replace the four screws (M2.5x6L) that secure the display assembly to the palm-rest assembly.
4. Turn the computer over.
5. Route the display cable through the routing guides on the palm-rest assembly.
6. Route the logo-board cable through the routing guides on the palm-rest assembly.
7. Route the antenna cables through the routing guides on the palm-rest assembly.
Post-requisites
1. Replace the
system
board.
2. Replace the battery.
3. Replace the
heat-sink
4. Replace the
coin-cell
5. Replace the
computer
6. Replace the
rear-I/O
7. Replace the
memory
modules.
8. Replace the
solid-state
9. Replace the
wireless
card.
10. Replace the
base
cover.
50
computer. After working inside your computer, follow the instructions in
assembly.
battery.
base.
cover.
drive.
After working inside your
Advertisement
Table of Contents
