Table of Contents
Advertisement
Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
NOTE: These instructions are applicable only for laptops with a non-touch screen display.
1. Remove the
base
cover.
2. Remove the
wireless
card.
3. Remove the
memory
modules.
4. Remove the
solid-state
5. Remove the
rear-I/O
6. Remove the
computer
7. Remove the
coin-cell
8. Remove the battery.
9. Remove the
system
board.
10. Remove the
display
assembly.
11. Remove the
display
bezel.
Procedure
1. Using a plastic scribe, pry the camera module from the display back-cover and antenna assembly.
2. Peel the tape that secures the camera cable to the camera module and disconnect the camera cable from the camera module.
3. Lift the camera module from the display back-cover and antenna assembly.
4. Follow the procedure in step 2 in
60
computer. After working inside your computer, follow the instructions in
drive.
cover.
base.
battery.
Removing the display back-cover and antenna assembly
After working inside your
to remove the camera cable.
Advertisement
Table of Contents
