Keithley S46 Instruction Manual page 30

S46/S46T Microwave Switch System Instruction Manual
Connect devices to the GPIB as follows:
1.
2.
3.
4.
5.
Table 2-2
GPIB control connector terminals
Contact
number
* Numbers in parentheses refer to signal ground return of referenced contact
number. EOI and REN signal lines return on contact 24.
Line up the cable connector with the IEEE-488 connector located on the rear panel
of the S46/S46T. The connector's design allows installation to the port in only one
position.
Secure connector by tightening screws firmly (do not overtighten).
Add any additional connectors to the port as required.
Connect the free end of the cable to the controller.
Check that the primary address is properly set. (See
GPIB address information.)
IEEE-488 designation
01 DI01
02 DI02
03 DI03
04 DI04
05 EOI (24)*
06 DAV
07 NRFD
08 NDAC
09 IFC
10 SRQ
11 ATN
12 SHIELD
13 DI05
14 DI06
15 DI07
16 DI08
17 REN (24)*
18 Gnd (6) *
19 Gnd (7) *
20 Gnd (8) *
21 Gnd (9) *
22 Gnd (10) *
23 Gnd (11) *
24 Gnd, LOGIC
Section 3
Type
Data
Data
Data
Data
Management
Handshake
Handshake
Handshake
Management
Management
Management
Ground
Data
Data
Data
Data
Management
Ground
Ground
Ground
Ground
Ground
Ground
Ground
S46-901-01 Rev. C / January 2006
Connections 2-9
of this manual for