ECOTEST VIRTUOSO RKG-14 Operating Manual page 31

2.5.1.4 "Selected parameters"
In the next window that appears, all the parameters that you specified in the
previous paragraphs will be listed. You can also change the value of density of the
tested object. To do this, tap on "Edit" and enter a different value. If all the
parameters are correct, place the detector as it was selected in the previous step and
tap "START" to run the test (see Fig. 2.10). If there is a need to change some
settings, you can return to the window you need using the "Back" button of the
Android-device:
Figure 2.10 – Changing object density and starting the test
Attention: If you need to measure smaller activities than the minimum detected
activity (for non-optimal conditions), find a place for a test with a lower
background level or increase the object size.
29