Switching The Detecting Device On And Off - ECOTEST VIRTUOSO RKG-14 Operating Manual

The radiometer's detecting device is designed in a plastic dump- and
dustproof housing. The ingress protection rating is IP54. The housing of the
radiometer consists of covers (1, 2), a panel (3) and a battery compartment lid (4),
and a connector for storage battery charging (9). The "BATTERY" (5),
"COM." (6) and "BC" (battery charger (7)) light-emitting diodes (LEDs), as well
as the on/off button
There is a compartment (10) for storage battery (11) on the cover (1), which
is closed with the lid (4) with two screws (12).
The radiometer's detecting device includes: the scintillation detecting unit of
gamma radiation CsI(Tl) of 23 cm
spectrometric channel with the analogue-digital processing unit, the Bluetooth
radio channel module and the battery charging circuit.

1.5 Switching the detecting device on and off

The detecting device is switched on by pressing the
detecting device switches on, the "COM." LED (6) should be highlighted and start
blinking quickly (twice a second).
The detecting device switches off automatically every 3 minutes provided
that the Android device is not connected to it, or it can be switched off either
operated by the Android device when exiting "Virtuoso" application, or when the
storage battery capacity is critically low. With the
(approximately 3 seconds) until "COM." (6) and "BATTERY" (5) start blinking
quickly, you can also force the detecting device to switch off.
The "BATTERY" (5) LED indicates the status of the detecting device's
storage battery. If the storage battery capacity is less than 25%, the "BATTERY"
LED starts blinking red once every two seconds; given the capacity is less than 5%,
the "BATTERY" LED blinks twice a second.
The "COM." (6) LED shows the status of connection between the Android
device and the radiometer's detecting device. If the connection is established, the
LED starts blinking once every 1.5 seconds. High-frequency blinking (10 times per
second) means that there is no connection with the Android device.
(8) of the detecting device are located on the panel.
3
volume with semiconductor photomultiplier, the
14
button (8). Once the
button (8) still held