Table of Contents
Advertisement
2.6.3.8 If the measurement progress indicator gains 100%, it does not mean
that everything has been completely and thoroughly measured. If you continue the
measurement time, the reliability and accuracy of measurement will increase.
2.6.3.9 The result will be much more reliable if we continue measurement
after 100% by tapping "CONTINUE SEARCH". If you stop measurement by
tapping "STOP" button, you will see the following message (see Fig. 2.51). If after
this interruption (during which the result correction takes place) measurement time
is prolonged, the measurement result will become even more accurate.
To return to the mode of gamma dose rate measurement, touch the "EXIT
TEST" button.
As you exit the mode of DER measurement from radiocesium, the
application warns you that measured data will be lost. If the progress indicator
reaches 100 %, you can save measurement data containing information about
geographical coordinates (if measurements were conducted in an open air),
specified parameters and obtained results. The process of saving is similar to the
process of measurement results saving on gamma radiation dose rate (see 2.4.1).
Figure 2.51 – Result correction
67
Advertisement
Table of Contents
