Pairing With The Tydom App; Pairing With A Window Sensor; Pairing With A Repeater - DELTA DORE Tybox 5701FP Quick Start Manual

5. Pairing with the Tydom app

Launch the Tydom app from your smartphone or tablet, then:
Settings -> My devices -> Add device -> Heating -> Electrical -> Tybox 5701FP (+ RF6700FP) ... and follow the
instructions.
For more information, refer to the section § "Operation with the Tydom application".

6. Pairing with a window sensor

Pairing with a window sensor means you can switch the heating to Frost Protection if a window opens (in the 10
seconds that follow).
1
> 3s
... ... ...
❶ Press the receiver button for 3
seconds until the red LED flashes.
❷ Briefly press the detector button.

7. Pairing with a repeater

If the radio range is too weak and the transmitter cannot be moved closer to the receiver, you can add an X3D
radio repeater to your setup (example: ERX 2000).
1
2
>3s
... ... ...
❶ Press the ERX 2000 receiver
button for 3 seconds until the red
LED flashes. Release the button.
❷ On the thermostat, press and
hold both the mode and + buttons
for 3 seconds..
The screen displays rF0x
(depending on the number of
paired products). Release the
button.
2
❸ Make sure that the receiver LED
has stopped flashing.
mode
3
>3s
❸ Press briefly on +. The screen
flashes until rF is displayed
depending on the number of paired
receivers and repeaters (❹) (e.g.
rF02 for 1 receiver and 1 repeater).
❸ Make sure that the repeater LED
is no longer flashing.
OFF
3
5
OFF
4 mode
EXIT
To exit the mode, briefly tap the
mode and + buttons simultaneously.
5