Page 1
Device compliant with the requirements of directives: 2004/108/CEE (Electromagnetic compatibility) and 2006/95/CEE (Low voltage safety) Because of changes in standards and equipment, the characteristics given in the text and the illustrations in this document are not binding unless confirmed by Delta Dore.
Frost (CALYBOX range, Driver range, etc.). Protection or configuration (installer) Adjustment buttons The MINOR 11 thermostat thus controls the corresponding temperature. 15 mm 33 mm 80 mm Order sent by Corresponding temperature the programmer...
Fit back the cover and lock it by pushing the moving tabs downward. Min. 40 cm IMPORTANT: Do not install the MINOR 11 on a Switch on the wall in contact with the outside or in an unheated installation. room (e.g. garage, etc.).
5- Connections 6- Switching on the unit for the first time When the MINOR 11 is first switched on, it starts up MINOR 11 Load Pilot Underfloor the “gradual heating” mode designed for new Wire sensor 10A - 230V underfloor heating systems for which a gradual heating is recommended (over a period of 20 days).
7.1 Choosing the temperature displayed (CF01) correct the difference (+/-5°C in increments of 0.1°C). : Temperature of the room measured by E.g. The temperature displayed is 19°C and the MINOR 11 temperature recorded is 20°C, so set : Current set-point temperature (default mode) +1°C.
7.4 Locking user access (CF06) 7.5 Choosing the installation type (CF07) Important: Before activating the user locking feature, This menu is used to determine the type of select the required operating mode ( installation so that the most suitable regulation settings are used.
, to make your choice (5°C to - § 7.7) or automatically after 2 minutes without pressing any +30°C or 5°C to 15°C for the button. In Comfort mode, MINOR 11 will regulate according to the set-point configured. - 14 - - 15 -...
10- Technical characteristics When a choice is made to display the current temperature (default mode, § 7.1), the first time the Electrical • 230 V, 50 Hz power supply, ±10% button is pressed will display room • Class II insulation temperature, pressing it a second time allows you •...
Mechanical • Dimensions: LxHxD = 80 x 80 x 48 mm • IP 30 • Wall-mounted on flush-mounted box • Installation in an environment with normal pollution levels Technical • Storage temperature: -10°C to +70°C • Operating temperature: 0°C to +40°C. 11- Maintenance Problem Diagnosis / Solutions...