Loading Transparencies In The Ohcf (1 Or 2 Trays) - Xerox 770 User Manual

5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. If necessary, set the skew adjustment levers to the desired position for your print job.
7. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings screen may be
displayed on the UI.
8. If changes have been made to the paper tray, select the Change Settings button;
otherwise proceed to the next step.
a) Make the desired selections for the Paper Type/Paper Weight, Paper Size, and
Paper Color.
b) If necessary make the desired changes to the paper curl and alignment adjustment.
Note
Refer to the System Administration for detailed information on the paper curl and
alignment adjustment options.
c) Select Save until you are returned to the tray settings window.
9. Select Confirm to close the window.

Loading transparencies in the OHCF (1 or 2 Trays)

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Fan the transparencies to stop them from sticking together before loading into the
tray.
4. Load transparencies on top of a small stack of same-size paper and align the edge
of the transparency against the right edge of the as shown in following illustration:
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. If necessary, set the skew adjustment levers to the desired position for your print job.
®
Xerox 770 Digital Color Press
User Guide
Oversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
13-5